How you remove the door depends on its design.
Sliding glass door roller replacement diy.
You can find replacement patio sliding glass door hardware here.
First lift the rollers off the track by sliding a flat head screwdriver or putty knife under the roller and pushing up.
Replace the roller if the rollers or sliding glass door wheels are full of dirt and debris give them a good cleaning and a few drops of lubricant and see if they spin freely.
Grasp both sides of the frame and lift the door up off of its tracks.
In some cases you may be able to clean out the rust and re adjust the rollers but usually you will need to go ahead and replace both.
However if the rollers are worn cracked or bent remove them photo 4 and replace them with a new pair.
In this video we show you how to replace a roller in a patio sliding glass door.
Tap the block with a rubber mallet to release the frame.
Remove the screen door if you have one.
Pry the original door rollers from the bottom of the door with a.
Replace the roller screws and use your phillips screwdriver to turn them clockwise until tight.
Place the screen doors safely off to the side until you are ready to put them back.
Insert the new rollers in the door lining up the holes on the rollers with the holes in the bottom of the door insert the new rollers in place.
Make sure the rollers spin sufficiently before re installing your sliding glass door.
You may have to lift the roller door out of the track and over the frame or you may have to unscrew the stationary door from its frame and then lift the roller door out.
Place a wooden block against the bottom frame on the sliding door.